11.To remove a memory module, press outward on the two latches on each side of the SODIMM (1), then pull the SODIMM out of the socket (2).

Figure 3-17Removing a memory module

12.To install a memory module, slide the SODIMM into the socket at approximately a 30° angle (1), then press the SODIMM down (2) so that the latches lock it in place.

Figure 3-18Installing a memory module

NOTE: A memory module can be installed in only one way. Match the notch on the module with the tab on the memory socket.

13.Engage the three tabs on the right edge of the fire enclosure shield with the matching slots on the right side of the chassis and rotate the fire enclosure shield down onto the chassis.

14.Fasten the two screws to secure the fire enclosure shield to the chassis.

15.Place the VESA panel onto the chassis and fasten the three screws to secure the VESA panel to the chassis.

16.Set the top edge of the access panel down on the top edge of the computer chassis (1). Be sure to align the hooks on the underside of the top edge of the access panel with the top edge of the computer.

26 Chapter 3 Hardware repair and upgrade