Mount Gun
Reciprocating Arm Rod Mount
Manifolds 241161 and 241162
To mount the gun on a reciprocating arm rod [0.5 in. (13 mm) diameter maximum]:
1.Insert the mounting bar (A) through the hole in the manifold as shown in FIG. 3.
Use the 1/8 in. alignment pin (P) to assist in 
orienting the gun.
2.Secure the gun to the bar by tightening the mount- ing screw (B).
3.Ensure the tip of the gun is 8 to 10 in. (150 to 200 mm) from the surface of the object being sprayed.
B
P
A
TI8111a
FIG. 3: Reciprocating Arm Mount
Installation
Stationary Support Mount
All Manifolds
To mount the gun on a stationary support (refer to FIG.
4.and Mounting Hole Layout, page 28):
1.Attach the gun to the support with two M5 x 0.8 cap- screws (C). The screws must be long enough to engage the threaded holes in the gun manifold to a depth of 1/4 in. (6 mm).
2.Ensure the tip of the gun is 8 to 10 in. (150 to 200 mm) from the surface of the object being sprayed.
CTI8112a
FIG. 4: Stationary Support Mount
311053C | 7 |
