HP 3210, 3210v, 3210xi A2 Connect the USB cable, A3 Go to back of the guide to make a test copy

1 12

Windows Users:

aFollow the onscreen instructions until you see the prompt to connect the USB cable. (This may take several minutes.)

Once the prompt appears, connect the USB cable to the port on the back of the

HP All-in-One, and then to any USB port on your computer.

Macintosh Users:

aConnect the USB cable from your computer to the USB port on the back of the device.

b Double-click the HP All-in-One installer icon.

c Make sure you complete all screens, including the Setup Assistant.

bFollow the onscreen instructions. Complete the Sign up now screen.

8 • HP All-in-One

Contents

USB cable users: Do not connect the USB cable until this 1 guide instructs you to or the software may not install properly Remove all tape and lift display 3 Locate components Attach the control panel faceplate 4 (if not attached) 5 Load paper trays 6 Connect the power cord 7 Press the On button and conﬁgure 8 Open the access door 9 Lift latches inside of the device 10Insert all six ink cartridges 11Close the access door and follow the prompts 12Turn on your computer 13Choose ONE connection type (A or B) A: USB Connection - Do not connect yet B: Ethernet (Wired) Network Section A: USB Connection A1 Insert the correct CD A2 Connect the USB cable A3 Go to back of the guide to make a test copy Section B: Ethernet (wired) network Connect the Ethernet cable B2 Insert the correct CD B4 Go to back of the guide to make a test copy Make a test copy