Audiovox ACD83 Setting The Clock / Error Codes, Cd Player Error Codes, 128-6003A 12 of

SETTING THE CLOCK / ERROR CODES

NOTES ON USE OF FRONT PANEL:

1.Make sure the front panel is positioned correctly when attaching it to the chassis as it cannot be attached when up-side down. Use modeate pressure to fully seat the panel into position.

2.To verify correct panel installation, swing the panel assembly up into position until it locks easily into place. If any resistance is encountered, re-check panel opientation in chassis mounting plate.

3.When taking the front panel with you, please use the supplied carrying case to protect the panel from dirt and damage. Make sure there is no dust or dirt on the electrical terminals on the back of the panel as this could cause intermittent operation or other malfunctions.

DISC SLOT

(19)RESET BUTTON (31)

THEFT DETERRENT

LED (30)

MOUNTING PLATE	CD EJECT
GUIDE (2 PLACES)	BUTTON (27)

FRONT PANEL

PANEL

MOUNTING

PLATE

OPERATING INSTRUCTIONS /

11

SETTING THE CLOCK

1.Switch the vehicle ignition and radio “on”.

2.Press the Time/Frequency (T/F) button to call the time display.

3.Within 10 seconds, press and hold the T/F button until a single beep sounds and the time display flashes.

4.With the display flashing, press the Up TUNE/SEEK/TRACK ( ) button to adjust

the hours and A/P indication, or the Down TUNE/SEEK/TRACK ( ) button to adjust the minutes to the correct time.

5.Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and the display will return to the normal indication.

CD PLAYER ERROR CODES

If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display panel. This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control of the player. If an error code should appear, try ejecting and re-loading the disc into the player. While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the RESET button dmon the unit, but this will also erase the time and pre-set memories.

If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.

128-6003A

12 of 20