Audiovox ACD83 128-6003A 11 of, Operating Instructions, cs DISC EJECT, cu EQUALIZER BUTTON EQ

the D.UP button, and to return to a lower num- ber disc, press the D.DN button. The number of the disc in play will be shown on the display panel.

cs DISC EJECT ( )

Disc play is stopped and the disc is ejected when the front panel is folded down and this button on the rear of the panel is pressed. Radio operation will automatically resume. If the disc is not removed from the unit within 15 seconds of being ejected, it will automatically be re-loaded into the unit to prevent it from being accidentally damaged ( will appear on the display panel to indicate that a disc is loaded in the player). Play of the disc can be resumed by using the MODE button bt to choose the CD player function.

ct TIME/FREQUENCY SELECTOR (T/F)

During radio, CD Player or optional CD Changer operation, press this button to call the time display on the incorporated quartz clock. The current time will appear together with an A or P indication. The display will return to the radio frequency indication after 5 seconds.

cu EQUALIZER BUTTON (EQ)

The EQ button applies preset sound effects to the unit’s audio output signal.The EQ button, when pressed, will activate one of five operating modes (CLASSICS, POP, JAZZ, DSP OFF or FLAT). Even though the Equalizer function is active, as displayed on the panel, if the bass and/or treble level is set, the Equalizer function automatically returns to the FLAT mode. Conversely, when the Equalizer function is not active, the unit returns to the user set bass and treble levels.

dl THEFT-DETERRENT LED

Located on the chassis behind the front panel, a light-emitting diode (LED) will flash when the panel is physically removed. The flashing light serves as a visual warning to the would-be thief that the unit has been disabled by removal of the front panel.

dm RESET BUTTON

The RESET button is located above and to the right of the theft deterrent LED. The reset circuitry should only be activated under the following circumstances as it will erase the time and pre-set memories:

1.Upon initial installation after all wiring is completed.

2.If there is a malfunction of any of the switches on the unit, pressing the RESET button may clear the system and return to normal operation.

dn FRONT PANEL RELEASE BUTTON (OPEN)

This button is used to release the mechanism that holds the front panel to the chassis. To detach the front panel, press the button so that the panel drops to the lowered position. Grasp the panel at the middle and pull it off of the chassis mounting plate. To re-attach the panel, press it straight onto the chassis mounting plate until the mechanism locks it into place.

do REMOTE SENSOR

The sensor to detect the infrared signal from the wireless remote control is located behind the VFD display lens. For optimum operation of the remote control, always aim the control at the VFD display.

OPERATING INSTRUCTIONS

10

128-6003A

11 of 20