HP 410 E&M Parameters, DID Parameters, DID channel in H.323 voip system, Figure 4: Voip Caller ID Case #4 – Remote FXS call on H.323 voip system

Chapter 3 – Related MultiVOIP Setup Parameters

Call is received

CID Flow

Call originates here

here.

CID

CID

Ch1

FXS

at 4:51pm, Oct 3.

Terminating

Generating

FXS

VoIP

VoIP

401

J.Q. Public

IP

xxxyyyzzzz

Ch2

402

phone of:

Nigel Thurston

xxxyyyzzzz

J.Q. Public

Network

Ch3

Clock:

403

763-555-9401

10/03, 4:51pm

Ch4

Display shows:

H.323 Protocol*

404

CID Number: 423

CID Name: Anoka-Whse-VP3

Time Stamp: Date: 10/03

Time: 4:51pm

*In x.06 release, when SIP protocol is used, CID Name field will duplicate value in CID Number field.

Phone Book Configuration

Gateway Name: Anoka-Whse-VP3

Q.931 Parameters	Inbound Phone Book {Channel 2}
	Remove Prefix Add Prefix Forward/Addr
Gatekeeper RAS Parameters
		423
		748

Figure 4: Voip Caller ID Case #4 – Remote FXS call on H.323 voip system

Call is received

CID Flow

Call originates here

here.

CID

CID

at

6:17pm, Nov 15.

FXS

Terminating

Generating

Ch1

DID

Central Office

VoIP

VoIP

without

Network

Ch2

standard telephony

J.Q. Public

J.Q. Public

xxxyyyzzzz

IP

xxxyyyzzzz

Clock:

Ch3

Caller ID service

11/15, 6:17pm

Display shows:

H.323 Protocol*

Ch4

phone of:

Edwin Smith

CID Number: 423

763-743-5873

CID Name: Anoka-Whse-VP3

Phone Book Configuration

Gateway Name:

Anoka-Whse-VP3

Time Stamp: Date: 11/15

Time: 6:17pm

Q.931 Parameters

Inbound Phone Book {Channel 2}

In x.06 release, when SIP protocol is used,

Remove Prefix

Add Prefix Forward/Addr

*CID Name field will duplicate value in

Gatekeeper RAS Parameters

CID Number field.

423

748

Figure 5: Voip Caller ID Case #5 – Call through telco central office without standard CID enters

DID channel in H.323 voip system

E&M Parameters. E&M is not supported if “Register with Communication Manager” is enabled.

DID Parameters. The parameters applicable to the Direct Inward Dial (DID) telephony interface type are shown in the figure below and described in the table that follows. The DID interface allows one phone line to direct incoming calls to any one of several extensions without a switchboard operator. Of course, one DID line can handle only one call at a time. The parameters described here pertain to the customer- premises side of the DID connection (DID-DPO, dial-pulse originating); the network side of the DID connection (DID-DPT, dial-pulse terminating) is not supported.

Multi-Tech Systems, Inc. Avaya Communication Manager Guide 49