Manuals / HP / Cell Phone / Cell Phone

HP 600 manual Power down

Models: 600

1 52

Download 52 pages 37.33 Kb

Page 13

To power up the MDS600:

1.Complete server hardware installation and cabling. See the server blade documentation.

2.Connect the SAS cables and power cords to the MDS600.

3.Press and hold the Power On/Standby button.

Wait and observe the system power LED and system fans. When the MDS600 powers up, the system power LED illuminates solid green and the system fans spin to a high speed, and then spin down to a low speed.

4.Power up the servers. See the server blade documentation.

Power down

Be sure that the partner servers are the first units to be powered down and the last to be powered back up. Taking this precaution ensures that the system and the OS are shut down in an orderly manner.

IMPORTANT: If installing a hot-plug device, it is not necessary to power down the MDS600.

To power down the MDS600:

1.Power down the partner servers. See the server documentation.

2.Press and hold the Power On/Standby button for approximately 4 seconds. This action powers down both hard drive drawers.

Operations 13

Image 13

HP 600 manual Power down

Contents

HP StorageWorks 600 Modular Disk System User Guide Page Contents Electrostatic discharge Front panel components Component identificationDescription Status Front panel LEDs and buttonGSI LED Rear panel componentsRear panel LEDs and buttons Blue flashing = System is in hard drive Device bay ID numbers SAS and Sata hard drive LEDs SAS and Sata hard drive LED combinations Power up Firmware updateOperations Power down Temperature requirements SetupSpace and airflow requirements Electrical grounding requirements Power requirementsRack warnings Installing the enclosureThird-party racks Site planning considerationsSetup SAS and Sata hard drive guidelines Hard drive overviewInstalling the hard drives Remove the hard drive blank Prepare the hard drive Installing the I/O module SAS cabling guidelines Cabling the MDS600Power cords Configuration tools Configuration and utilitiesArray Configuration Utility Option ROM Configuration for ArraysManagement tools Diagnostic toolsRemote support and analysis tools Array Diagnostic UtilityHP Insight Remote Support software Change control and proactive notification Keeping the system currentCare Pack When the MDS600 does not power up TroubleshootingLED behavior = System Fan Segment display status codes and actionsRecognizing hard drive failure Compromised fault toleranceEffects of a hard drive failure Factors to consider before replacing hard drives Recovering from compromised fault toleranceTime required for a rebuild Automatic data recovery rebuildFailure of another drive during rebuild Regulatory compliance identification numbers Regulatory compliance noticesFederal Communications Commission notice FCC rating labelClass B equipment Cables ModificationsCanadian notice Avis Canadien European Union regulatory noticeRegulatory compliance notices Japanese notice Bsmi notice Korean notice Chinese notice Ukraine notice Power cord statement for JapanVietnam compliance marking notice Preventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge Environmental specifications SpecificationsStorage array specifications Before you contact HP Technical supportHP contact information Customer Self RepairRéparation par le client CSR Riparazione da parte del cliente Reparaciones del propio cliente Reparo feito pelo cliente Technical support Technical support Technical support Acronyms and abbreviations Index LED, UID