TM 11-6625-2965-14&P
SECTION II
INSTALLATION
2-1 INITIAL INSPECTION
2-2 Before shipment, this instrument was inspected and found to be free of mechanical and electrical defects. As soon as the instrument is unpacked, inspect for any damage that may have occurred in transit. Save all packing materials until the inspection is completed. If damage is found, a claim should be filed with the carrier. Hewlett-Packard Sales and Service office should be notified.
2-3 MECHANICAL CHECK
2-4 This check should confirm that there are no broken knobs or connectors, that the cabinet and panel surfaces are free of dents and scratches, and that the meter is not scratched or cracked.
2-5 ELECTRICAL CHECK
2-6 The instrument should be checked against its electrical specifications. Section V includes an
“in-cabinet” performance check to verify proper instrument operation,
2-7 INSTALLATION DATA
2-8 The instrument is shipped ready for bench operation. It is necessary only to connect the instrument to a source of power and it is ready for operation.
2-9 LOCATION
2-10 This instrument is air cooled. Sufficient space should be allotted so that a free flow of cooling air can reach the sides and rear of the instrument when it is in operation. It should be used in an area where the ambient temperature does not exceed 50°C.
2-11 OUTLINE DIAGRAM
2-12 Figure 2-1is an outline diagram showing the dimensions of the instrument.
2-13 RACK MOUNTING
2-14 This instrument may be rack mounted in a standard 19 inch rack panel either alongside a similar unit or by itself. Figures 2-2and 2-3 show
Figure 2-1. Outline Diagram
how both types of installations are accomplished.
2-15 | To | mount two | units | side-by-side, | proceed |
as follows: | | | |
| a . | Remove the | four | screws from | the front |
panels | of | both units. | | | |
| b. Slide rack mounting ears between the |
front panel and case | of each unit. | |
| c . Slide combining strip between the front |
panels | and cases of the two units. | |
| d. After fastening rear portions of units to- |
gether using the bolt, nut, and spacer, replace |
panel | screws. | | | |
2-16 To mount a single unit in the rack panel, proceed as follows:
a.Bolt rack mounting ears, combining straps, and angle brackets to each side of center
