3 View images on a television

You can use your dock to review your images on a TV.

Displaying images on a TV using the dock

1.Connect the audio/video cable between the camera dock and your TV and confirm that the power cable is plugged into the dock. See Setting up the dock.

Tip If you cannot locate video and audio input jacks on your TV to fit the connectors on the audio/video cable, you should be able to use the video and audio input jacks on a video cassette recorder (VCR) or DVD player connected to your TV.

2.Your camera will send either an NTSC or a PAL video signal to a TV, depending on the language you selected when you set up your camera. The NTSC format is used primarily in North America and Japan, and the PAL format is used primarily in Europe. If your TV accepts a different video signal from the default setting for your language, you must change the TV configuration setting in your camera. (See your camera electronic User Guide.)

3.Your camera will be the source for the TV signal (just like a VCR or a camcorder), so you must set the TV to take video input from an external video source (your camera) instead of the antenna or cable TV. Refer to the TV user guide for directions on how to do this.

4.Insert the camera into the camera dock. The camera will turn on automatically.

5.Press the TV button on the dock or the dock remote control. The first image in the camera is displayed on the TV. You can use the ￿￿ buttons to navigate

through a slide show of the images on the camera, or press to start an automatic slide show of each image, playing any attached audio clip or video clip, and then changing to the next image.

6.To end the slide show, press the TV button again.

Note The Image Display on the camera turns off when the camera is connected to a TV, but you can still use the camera’s menus because the menus will display on the TV screen.

Using the remote

You can use the dock remote control to pause the slide show, magnify an image, rotate an image, select an image for HP Photosmart Share, or mark an image for printing.

Before you can use the remote, you need to install the remote control battery.

User Guide

7