Front I/O assembly
The front I/O assembly is attached to the front of the chassis. Push the assembly into the chassis to remove.
1.Prepare the computer for disassembly (Preparation for disassembly on page 72).
2.Remove the access panel (Access panel on page 73).
3.Remove the front bezel (Front bezel on page 73).
4.Rotate the drive cage to its upright position.
5.Disconnect the cables from the system board as follows:
●(1) Yellow connector labeled FRONT_USB
●(2) Blue connector labeled FRONT AUD
●(3) Blue connector labeled FRONT_USB3.0
Front I/O assembly 103