10.If the system configuration includes only one optical drive, connect the SATA data cable to the light blue system board connector. If you are adding a second optical drive, connect the SATA data cable to the orange system board connector.

11.Connect the power cable (1) and data cable (2) to the rear of the optical drive. Figure 18 Connecting the Power and Data Cables

12.Replace the front bezel and access panel.

13.Reconnect the power cord and turn on the computer.

14.Lock any security devices that were disengaged when the access panel was removed. The system automatically recognizes the drive and reconfigures the computer.

Removing an External 3.5-inch Drive

CAUTION: All removable media should be taken out of a drive before removing the drive from the computer.

NOTE: The 3.5-inch drive bay may contain a media card reader.

1.Remove/disengage any security devices that prohibit opening the computer.

2.Remove all removable media, such as compact discs or USB flash drives, from the computer.

3.Turn off the computer properly through the operating system, then turn off any external devices.

4.Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer.

5.Remove the access panel and front bezel.

6.Disconnect the USB cable from the system board.

ENWW

Installing Additional Drives 19