9.Connect the power and data cables to the drive as indicated in the following illustrations.

a.If you are installing an optical drive, connect the power cable (1) and data cable (2) to the back of the drive.

NOTE: The power cable for the optical drives is a two-headed cable that is routed from the system board to the rear of the optical drive bays.

Figure 2-23Connecting the Optical Drive Cables

b.If your are installing a media card reader, connect the USB cable to the USB system board connector labeled MEDIA.

Figure 2-24Connecting the Media Card Reader USB Cable

10.If you are installing a new drive, connect the opposite end of the data cable to the appropriate system board connector.

NOTE: If you are installing a new SATA optical drive, connect the data cable for the first optical drive to the white SATA connector on the system board labeled SATA2. Connect the data cable for a second optical drive to the white SATA connector on the system board labeled SATA3.

Refer to System Board Connections on page 23 for an illustration of the system board drive connectors.

40 Chapter 2 Convertible Minitower (CMT) Hardware Upgrades

ENWW