4.Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: You must disconnect the power cord and wait approximately 30 seconds for the power to drain before adding or removing memory modules. Regardless of the power-on state, voltage is always supplied to the memory modules as long as the computer is plugged into an active AC outlet. Adding or removing memory modules while voltage is present may cause irreparable damage to the memory modules or system board.

5.Remove the computer access panel.

WARNING! To reduce risk of personal injury from hot surfaces, allow the internal system components to cool before touching.

6.Open both latches of the memory module socket (1), and insert the memory module into the socket (2).

Figure 3-9Installing a DIMM

NOTE: A memory module can be installed in only one way. Match the notch on the module with the tab on the memory socket.

Populate the black DIMM sockets before the white DIMM sockets.

For maximum performance, populate the sockets so that the memory capacity is spread as equally as possible between Channel A and Channel B. Refer to Populating DIMM Sockets on page 65 for more information.

7.Push the module down into the socket, ensuring that the module is fully inserted and properly seated. Make sure the latches are in the closed position (3).

8.Repeat steps 6 and 7 to install any additional modules.

9.Replace the computer access panel.

10.Reconnect the power cord and turn on the computer.

11.Lock any security devices that were disengaged when the access panel was removed.

The computer should automatically recognize the additional memory the next time you turn on the computer.

66 Chapter 3 Microtower (MT) Hardware Upgrades

ENWW