7.Make sure the sealed edge of the laminating film is inserted first into the Lamina- tor to avoid jamming. Keep hands and fingers clear of the Adjustable Front
Guide (6).
8.Once inserted into the Laminator, the laminating object will be automatically drawn into the Laminator and ejected from the Rear Guide Platform (7). To avoid pos- sible accidental burns, make sure to wear safety gloves (not included) when first removing the laminating object from the Rear Guide Platform.
(See Assy. Diagram.)
9.NOTE: For best results: Set a higher temperature if the laminated object appears milky white, cloudy, or crumpled vertically. Set a lower temperature if the laminated object appears crumpled horizontally or bubbled.
10.When finished laminating, turn the Power Switch (1) to its “OFF” position and unplug the Laminator from its electrical outlet. Allow the Laminator to completely cool. Then store the unit in a dry, dust free location out of reach of children. (See Figure D.)
INSPECTION, MAINTENANCE, AND CLEANING
1.WARNING! Make sure the Power Switch (1) of the Laminator is in its “OFF” position, the Power Cord (2) is unplugged from its electrical outlet, and the unit has completely cooled before performing any inspection, maintenance, or cleaning procedures.
2.Before each use: Inspect the general condition of the Laminator. Check for mis- alignment or binding of moving parts, damaged electrical wiring, cracked or broken parts, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3.To clean: Use a clean cloth and a mild detergent. Do not use solvents. Do not immersed any part of the Laminator in liquids.
4.To replace the External Fuse (8): A blown Fuse is typically the cause if the Laminator does not turn on, even though it is plugged in to its electrical outlet and the Power Switch (1) is turned to its “ON” position. To check or replace the Fuse, first unplug the electrical cord and turn Power Switch “OFF”. Then unscrew and remove the Fuse Cap to expose the Fuse. Remove the Fuse, and replace it with a 3.15A/250V Glass Fuse (not included). Then, replace the Fuse Cap. (See Assy. Diagram.)
5.All maintenance, service, and repairs not listed in this manual are only to be at- tempted by a qualified technician.
SKU 92500 | For technical questions, please call | PAGE 10 |