Chapter 2
1.On the control panel of the HP
2.Press 
until Network is highlighted, and then press OK. The Network Menu appears.
3.Press 
until View Network Settings is highlighted, and then press OK. The View Network Settings Menu appears.
4.Do one of the following:
•To display wired network settings, press 
until Display Wired Summary is highlighted, and then press OK.
This displays a summary of the wired (Ethernet) network settings.
•To print the network configuration page, press 
until Print Network Configuration Page is highlighted, and then press OK.
This prints the network configuration page.
Restore network defaults
You can reset the network settings to what they were when you purchased the HP
1.On the control panel of the HP
2.Press 
until Network is highlighted, and then press OK.
3.Press 
until Restore Network Defaults is highlighted, and then press OK.
4.Press OK to confirm that you want to restore the network defaults.
Change advanced network settings from the control panel settings
The advanced network settings are provided for your convenience. However, unless you are an advanced user, you should not change any of these settings.
setup Network
Set link speed
You can change the speed at which data is transmitted over the network. The default is Automatic.
1.Press Setup.
2.Press 
until Network is highlighted, then press OK. The Network Menu appears.
3.Press 
until Advanced Setup is highlighted, and then press OK. Press 
until Set Link Speed is highlighted, and then press OK.
4.Press 
to select the link speed that matches your network hardware, and then press OK to confirm the setting.
•Automatic
•10-Full
•10-Half
•100-Full
•100-Half
Change IP settings
The default setting for the IP settings is Automatic, which sets the IP settings automatically. However, if you are an advanced user, you might want to manually change the IP address, subnet mask, or the default gateway. To see the IP address and subnet mask of the HP
10 Network setup