POST Error Messages Continued |
|
|
|
Screen Message | Beeps* | Probable Cause | Recommended Action |
None | Integrated video controller | Replace system board if minimal | |
Detected Unreliable |
| display cache not working | video degrading is an issue. |
|
| properly and will be disabled. |
|
None |
| No action required. | |
Been Removed Since Last |
|
|
|
System Start Up |
|
|
|
None | Hood lock mechanism is | 1. Reconnect or replace hood | |
Connected |
| missing or not connected. | locking mechanism. |
|
|
| 2. Reseat or replace hood locking |
|
|
| mechanism cable. |
None | Processor heatsink cable not | |
Processor Heatsink is not |
| connected to system board. |
Connected. |
|
|
None | Riser board not seated or not | |
Detected |
| installed. |
2S | Both external and internal | |
Conflict Detected |
| serial ports are assigned to |
|
| COM1. |
Both external and internal | |
Conflict Detected | serial ports are assigned to |
| COM2. |
1155- Serial Port Address | 2S | Both external and internal |
Conflict Detected |
| serial ports are assigned to |
|
| same IRQ. |
Reseat or replace the processor heatsink cable going to the system board.
Install riser board if missing or remove and reseat to ensure good connection.
1.Remove any Comm port expansion cards.
2.Clear CMOS.
3.Reconfigure card resources and/or run Computer Setup (F10 Setup).Run Computer Setup or Windows utilities.
1.Remove any Comm port expansion cards.
2.Clear CMOS.
3.Reconfigure card resources and/or run Computer Setup (F10 Setup).Run Computer Setup or Windows utilities.
1.Remove any Comm port expansion cards.
2.Clear CMOS.
3.Reconfigure card resources and/or run Computer Setup (F10 Setup). Run Computer Setup or Windows utilities.
Device IRQ address conflicts Reset the IRQ. | |
Conflict Detected | with another device. |
* L = Long, S = Short |
|
continued |
|
Quick Troubleshooting Guide |