Chapter 7
Use PIN method
a. Select setup method.
❑Touch Setup.
❑Touch Network.
❑Touch WiFi Protected Setup.
❑Touch PIN.
b. Set up wireless connection.
❑Touch Start.
The device displays a PIN.
❑Enter PIN on
NOTE: The product begins a timer for approximately two minutes in which the PIN needs to be entered on the networking device.
❑Touch OK.
c. Install software.
Wireless with a router (infrastructure network)
To connect the HP ENVY to an integrated wireless WLAN 802.11 network, you will need the following:
❑A wireless 802.11 network that includes a wireless router or access point.
❑A desktop computer or laptop with either wireless networking support, or a network interface card (NIC). The computer must be connected to the wireless network that you intend to install the HP ENVY on.
❑Broadband Internet access (recommended) such as cable or DSL.
If you connect the HP ENVY on a wireless network that has Internet access, HP recommends that you use a wireless router (access point or base station) that uses Dynamic Host Configuration Protocol (DHCP).
❑Network name (SSID).
❑WEP key or WPA Passphrase (if needed).
To connect the printer with the Wireless Setup Wizard
1.Write down your network name (SSID) and WEP key or WPA passphrase.
2.Start Wireless Setup Wizard.
▲Touch Wireless Setup Wizard.
3.Connect to wireless network.
▲Select your network from the list of detected networks.
4.Follow prompts.
5.Install software.
Related topics
32 Connectivity