HP dx7300 manual Embedded Security, Device Security, Network Service Boot, System IDs

Models: dx7300

1 19
Download 19 pages 7.47 Kb
Page 14
Image 14

Table 4 Computer Setup—Security (continued)

Embedded Security

(This menu item only appears after the Embedded Security Device is made available under Device Security.)

Allows you to:

Enable/disable the Embedded Security device

Reset the device to Factory Settings

Enable/disable power-on authentication support. (some models)

Reset authentication credential. (some models)

This feature is supported on some models only. See the Desktop Management Guide on the

Documentation and Diagnostics CD for more information.

Device Security

Allows you to set Device Available/Device Hidden for

 

Serial ports

 

Parallel port

 

All USB ports

 

Front USB ports

 

System audio

 

Network controllers (some models)

 

SMBus controller (some models)

 

SCSI controllers (some models)

 

Embedded security device (some models)

 

 

Network Service Boot

Enables/disables the computer’s ability to boot from an operating system installed on a network

 

server. (Feature available on NIC models only; the network controller must be either a PCI expansion

 

card or embedded on the system board.)

 

 

System IDs

Allows you to set:

 

Asset tag (18-byte identifier) and ownership tag (80-byte identifier displayed during POST).

 

 

See the Desktop Management Guide on the Documentation and Diagnostics CD for more

 

 

information.

 

Chassis serial number or Universal Unique Identifier (UUID) number. The UUID can only be

 

 

updated if the current chassis serial number is invalid. (These ID numbers are normally set in

 

 

the factory and are used to uniquely identify the system.)

 

Keyboard locale setting (for example, English or German) for System ID entry.

 

 

DriveLock Security

Allows you to assign or modify a master or user password for hard drives. When this feature is

 

enabled, the user is prompted to provide one of the DriveLock passwords during POST. If neither

 

is successfully entered, the hard drive will remain inaccessible until one of the passwords is

 

successfully provided during a subsequent cold-boot sequence.

NOTE: This selection will only appear when at least one drive that supports the DriveLock feature is attached to the system.

See the Desktop Management Guide on the Documentation and Diagnostics CD for more information.

8 Computer Setup (F10) Utility

ENWW

Page 14
Image 14
HP dx7300 manual Embedded Security, Device Security, Network Service Boot, System IDs, DriveLock Security