Table 5 Computer Setup—Power (continued)
Hardware Power | SATA power management enables or disables SATA bus and/or device power management. | |||||
Management |
|
|
|
|
|
|
|
|
|
|
|
|
|
Thermal | ● Fan idle | |||||
|
|
|
|
|
|
|
|
|
|
|
| NOTE: This setting only changes the minimum fan speed. The fans are still automatically | |
|
|
|
| |||
|
|
|
|
| controlled. | |
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Computer Setup—Advanced
NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.
Table 6 Computer Setup—Advanced (for advanced users)
Option | Heading |
|
|
| Allows you to set: |
| ● POST mode (QuickBoot, FullBoot, or FullBoot every |
| ● POST messages (enable/disable). |
| ● MEBx Setup Prompt (enable/disable or hidden/displayed). Enabling this feature displays the |
| text CTRL+P = MEBx during POST. Disabling this feature prevents the text from being |
| displayed. However, pressing Ctrl+P still accesses the ME BIOS Extension Setup Utility, which |
| is used to configure manageability settings. |
| ● F9 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text F9 = |
| Boot Menu during POST. Disabling this feature prevents the text from being displayed. |
| However, pressing F9 will still access the Shortcut Boot [Order] Menu screen. See |
| Storage > Boot Order for more information. |
| ● F10 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text |
| F10 = Setup during POST. Disabling this feature prevents the text from being displayed. |
| However, pressing F10 will still access the Setup screen. |
| ● F11 prompt (hidden/displayed). Setting this feature to displayed will display the text |
| F11 = Recovery during POST. Hiding this feature prevents the text from being displayed. |
| However, pressing F11 will still attempt to boot to the HP Backup and Recovery partition. |
| See Factory Recovery Boot Support for more information. |
| ● F12 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text |
| F12 = Network during POST. Disabling this feature prevents the text from being displayed. |
| However, pressing F12 will still force the system to attempt booting from the network. |
| ● Factory Recovery Boot Support (enable/disable). Enabling this feature will cause an additional |
| prompt, F11 = Recovery, to be displayed during POST on systems with HP Backup and |
| Recovery software installed and configured with a recovery partition on the boot hard drive. |
| Pressing F11 causes the system to boot to the recovery partition and launch HP Backup and |
| Recovery. The F11 = Recovery prompt can be hidden with the F11 prompt (hidden/displayed) |
| option (see above). |
| ● Option ROM prompt (enable/disable) Enabling this feature will cause the system to display a |
| message before loading option ROMs. (This feature is supported on some models only.) |
|
|
10 Computer Setup (F10) Utility | ENWW |
