HP EN 6233, EN 6266, EN 6300, EN 6300A, EN 6300C, EN 6333, EN 6333C, EN 6350, EN 6366C, EN 6400, EN 6400C, EN 6433C, EN 6450, EN 6500, EN C466/810, EN C500/810, EN C533, EN C566, EN C600, EN C667/815E/10/64/I/9, EN C850, EN P1.13GHz, EN P1.2GHz, EN P533, EN P550, EN P667, EN P667 (na), EN P667/820, EN P700, EN P733, EN P733 (na), EN P733/820, EN P750, EN P800, EN P866, EN P933 Error, Keyboard, Keyboard, Keyboard, Keyboard, LED Color, LED Color, Conditions, Block Mode, LED Activity, LED Activity, State/Message, FailSafe Boot

Error	Keyboard	Keyboard
Conditions	LED Color	LED Activity	State/Message

Num Lock	Green	Flashing	System memory is not present
			or is incompatible.

Caps Lock	Green	Flashing	Graphics controller is not
			present or is incorrectly
			initialized.

Scroll Lock	Green	Flashing	System board hardware failure
			prior to graphics.

Num, Caps, Scroll Lock	Green	Chasing	Keyboard is locked in network
		(cycling from	server mode.
		left to right,
		continuously)

FailSafe Boot	Keyboard	Keyboard
Block Mode	LED Color	LED Activity	State/Message

Num Lock	Green	On	ROMPaq diskette not present,
			is bad, or drive not ready.*
			The screen displays a Boot
			Block Recovery message when
			using an embedded graphics
			controller, or a PCI or AGP
			graphics controller card.

Caps Lock	Green	On	Enter password.*

Num, Caps, Scroll Lock	Green	Turn on and	ROM flash failed.*
		off 2 times
		(accompanied
		by 1 long
		and 3 short
		beeps)

Num, Caps, Scroll Lock	Green	On	Boot Block ROM Flash
			successful. Turn power off, then
			on to reboot.

Note: Diagnostic lights do not flash on USB keyboards.

*Insert valid ROMPaq diskette in drive A. Turn power switch off, then on to reflash ROM. If ROM flash is successful, all three keyboard LEDs will light up and you will hear a rising tone series of beeps. Remove diskette and turn power off, then on to restart the computer. For more information about flashing the ROM, refer to the Troubleshooting Guide.

Getting Started 2-17