Husqvarna 2009-01, 966004501 manual 7INSTALLING BAGGER MOUNT, Assembly

ASSEMBLY

7INSTALLING BAGGER MOUNT

1.To select the right support straps to use, measure the mower frame just behind the casters, as shown.

For frames measuring 26" use support straps A, for frames measuring 23" use support straps B.

B

2.Install the bagger mount tube to the rear guard with 5/16-18 x 3¼ bolts and flange nuts from kit.

NOTE: Depending on model, rear guard hole may need to be drilled out to 5/16" if kit hardware is too large.

3.Install kit support straps on the outside of the mount tube as shown in the illustration. Using a

5/16-18 x 1¼ bolt, attach the front side of the strap to the fender support. Do not add flange nut at this time. Place the reinforcement plate to the outside of the fender support. Secure with additional 1¼ bolt and fasten both bolts with flange nuts. Repeat steps on opposite side.

NOTE: The front side of the kit support straps should be on the inside of the mower frame.

4.Tighten all hardware.

Drill rear guard hole to 5/16" if needed

Reinforcement Plate

Support Strap

A	Rear Guard
	Mount Tube

10