| ASSEMBLY |
|
|
8INSTALLING CHUTE SUPPORT | 9INSTALLING WEIGHT KITS |
1.Position upper chute support against bagger inlet, flush at outer edges. See Illustration.
2.Using support as a template, drill two 3/8 holes into bagger hood.
Upper Chute Support
Bagger Hood
1.Bolt cast weight to weight brackets using
2.Slide both weight brackets over the front tube on the frame. Be sure to position the weight assembly in the center of the frame.
3.Secure with
Front Tube
Bagger Inlet
3.Secure upper chute support to hood with hex bolts, washers and nyloc nuts.
Flex Trim
Nut | Flat Washers |
Hex Bolt
3" Bolt |
Weight Assembly 3½ Bolt 
Weight Bracket
CAUTION
DO NOT operate mower with grass catcher without front weights installed.
10MOUNTING COVER ASSEMBLY
NOTE: Assistance from another person may ease mounting the cover assembly to mower.
1.Lift and rotate cover to align the cover brackets with support assembly tubes.
2.Slide the cover down over the support tubes until secure.
11
