HP Enterprise File Services WAN Accelerator HP EFS N4c WAN Accelerator 4- port NIC Status Lights

HP EFS N4c

WAN Accelerator 4- port NIC Status Lights

8

The HP EFS WAN Accelerator is equipped with a bypass card to prevent a single point of failure. If there is a serious problem with the HP EFS WAN Accelerator, it goes into bypass mode and the traffic is passed through unoptimized. You can install multiple- port bypass cards to connect to multiple routers and switches.

The HP EFS N4c WAN Accelerator 4-port NIC, HP EFS N2c WAN Accelerator 2-port NIC, and HP EFS N2f WAN Accelerator 2-port NIC are supported by HP EFS WAN Accelerator, version 2.1.5 (or higher) software.

NOTE: There are hardware limitations on how many cards are supported.

The HP EFS N4c WAN Accelerator 4-port NIC, HP EFS N2c WAN Accelerator 2-port NIC, and HP EFS N2f WAN Accelerator 2-port NIC enable you to connect to multiple routers and switches connecting your Local Area Network (LAN) and Wide Area Network (WAN). With these bypass NICs, you can use the same data store in the HP EFS WAN Accelerator across multiple links in your network.

Figure 1-1.HP EFS N4c WAN Accelerator 4-port NIC

0	1	2	3
			LINK/ACT
			100
			BYPASS
			1000

The four columns of lights on the HP EFS N4c WAN Accelerator 4-port NIC represent the following interfaces:

‹Column 0 — WAN 1

‹Column 1 — LAN 1

‹Column 2 — WAN 0

‹Column 3 — LAN 0

The status lights for each column are explained below:

Light	Description
Link/Act (Link and	Solid green indicates a physical Ethernet link is established.
Activity)	Flashing green indicates data transfer is occuring.
100	Solid green indicates the link is connected at 100 Mbps speed.
1000	Solid green indicates the link is connected at 1000 Mbps speed.
100 and 1000—	When both lights are solid green, it indicates the card is in bypass
Bypass	mode.

1 - INSTALLING THE BYPASS NICS