If you want to change the detected printer language, use the LEDs and Test button to select a PDL for the configuration page. When you hold down the Test button for three seconds, the LEDs begin to cycle through four configurations, as outlined in the following table.
Release the Test button when you get the right PDLs, and the configuration page will be printed.
| The Status | And the Activity |
For PDL... | LED is... | LED is... |
|
|
|
HP PCL (default) | Off | Off |
|
|
|
ASCII | Off | On |
|
|
|
Postscript | On | Off |
|
|
|
On | On | |
|
|
|
When you first press the Test button, the Status and Activity LEDs are on and solid for about
Resetting to Factory Defaults
Once you have configured the HP JetDirect external print server, the configuration settings are retained in memory unless you manually reset them.
(The firmware is not affected when you reset the configuration settings.)
To reset the configuration settings to their factory defaults, follow these steps:
1.Unplug the power cord from the print server.
2.While holding down the Test button on the print server, plug the power module into the print server and continue to hold down the Test button for five seconds. All previous configuration settings will be erased.
