FP USER INSTRUCTIONS ENGLISH 71576286 - 07/06

All motors (for masses see the motor description plate) must be handled with a winch.

For masses above 25 kg (55 lb), manual handling is forbidden.

2.3 Lifting

2.3.1 Slinging of motor pumps units

2.4 Storage

Store the pump in a clean, dry location away from vibration. Leave piping connection covers in place to keep dirt and other foreign material out of pump casing. Turn pump at intervals to prevent brinelling of the bearings and the seal faces, if fitted, from sticking.

Do not store pumps starting on the fan guard.

Use handling means in accordance with motor pump unit mass mentioned on the CE plate. For the masses of the pumps bare end of shaft see table § 2.2.2 and nameplate.

To avoid distortion, the pump unit should be lifted as shown.

Motor pump unit

Bareshaft pump

When handling always wear gloves, safety boots and an industrial safety helmet.

For masses above 25 kg (55 lb), manual handling is forbidden.

The pump may be stored as above for up to 6 months. Consult Flowserve for preservative actions when a longer storage period is needed.

2.5 Recycling and end of product life

At the end of the service life of the product or its parts, the relevant materials and parts should be recycled or disposed of using an environmentally acceptable method and local regulations. If the product contains substances which are harmful to the environment, these should be removed and disposed of in accordance with current regulations. This also includes the liquids and or gases in the "seal system" or other utilities.

Make sure that hazardous substances or toxic fluid are disposed of safely and that the correct personal protective equipment is used. The safety specifications must be in accordance with the current regulations at all times.

3 PUMP DESCRIPTION

3.1 Configurations

The multi-stage centrifugal pump is designed for the pumping of cold water or all clear liquids which are not solid and liquid mixtures, non-corrosive, non- abrasive or non-explosive when in contact with the pump motor unit and its working parts (Important: for other liquids consult FLOWSERVE for beforehand advice).

The FP type pump is a centrifugal, multi-stage, single suction and radial joint plan pump.

The modular design (2 hydraulics by pump type, number of stages variation) enables an accurate pump adjustment to the required operating conditions.

It can be driven by electric motor, steam turbine, or petrol or diesel motor.

The pump must be stored in a non-explosive, ventilated location, sheltered from bad weather, dust and vibrations.

Page 11 of 35