Display assembly

Description

Spare part number

 

 

39.6-cm(15.6-in) High Definition (HD), light-emitting diode (LED) BrightView display assembly:

 

 

 

● For use in Charcoal Grey computer models

645523-001

 

 

● For use in Ocean Drive computer models

636378-001

 

 

● For use in Sonoma Red computer models

645521-001

 

 

● For use in Luminous Rose computer models

645522-001

 

 

● For use in Pewter computer models

645524-001

 

 

● For use in Pacific Blue computer models

645525-001

 

 

● For use in Pearl Pink computer models

645526-001

 

 

● For use in Sweet Purple computer models

645527-001

 

 

● For use in Butter Gold computer models

645528-001

 

 

Before removing the display assembly, remove the following components:

1.Battery (see Battery on page 43)

2.Service access cover (see Service access cover on page 44)

3.Optical drive (see Optical drive on page 47)

4.WLAN module (see WLAN module on page 49)

5.Keyboard (see Keyboard on page 52)

6.Top cover (see Top cover on page 55)

7.USB board (see USB board on page 62)

8.Power connector (see Power connector on page 63) Remove the display assembly:

1.Position the computer display-side up, with the front toward you.

2.Open the display as far as possible.

3.Disconnect the display panel cable (1) from the system board.

4.Pull the antenna cables through the opening in the base enclosure (2), and then disengage the cables from the clip in the routing channel leading to the display hinge.

CAUTION: Support the display assembly when removing the display screws in the following steps. Failure to support the display assembly can result in damage to the assembly and other components.

5.Remove the two Phillips 6.0×2.5 screws (3) that secure the display assembly to the computer.

64 Chapter 4 Removal and replacement procedures