cfg "HP-UX B.11.31 Default" {

description "This selection supplies the default system configuration that HP supplies for the B.11.31 release."

"/opt/ignite/data/Rel_B.11.31/config" "/opt/ignite/data/Rel_B.11.31/hw_patches_cfg" "/var/opt/ignite/config.local"

}

Of course, by itself, this can’t be used to install a system as it doesn’t have a configuration file referencing any software to be installed.

This section describes the per release configuration file /opt/ignite/data/Rel_B.11.31/config and explains what is happening and why certain things have been done in certain ways.

Please note the following text from the Ignite-UX C.7.0 release notes:

-Default file system sizes, primary swap size and other default system configuration settings have been changed in HP-UX 11i v3 as compared to prior HP-UX releases. This was important to better adjust to Operating Environment software and computer system hardware. Futher tuning of these configuration defaults may be done in a future Ignite-UX release. As before, it may be necessary or appropriate to create custom configurations specific for your systems. Such

custom configurations or recovery configurations will not be affected by future default configuration tuning.

The configuration presented in this section may not match that provided with Ignite-UX revisions greater than C.7.0, please be careful if you rely on the information provided here and ensure it is consistent with the release of Ignite-UX you are using.

The release-specific configuration file

The config file defines all of the file system and volume management configurations for the release (and a few other things). This description is based on the release-specific config file from Ignite-UX version C.7.0.

##########################################################################

#config:

#This file contains the default system definitions used during a

#cold-install of HP-UX. This file should not be modified. If

#modifications are needed, the file "config.local" should be modified

#instead.

#See the instl_adm(4) man page for details.

#

#Changes to this file will not be preserved if the fileset is re-installed.

#If you are editing this file via the advanced options during a

#cold-install, then notice that the "config.local" contents are appended

#to the end of this file.

#

#@(#) config $Revision: 10.11 $

#IGNITE_UX_COPYRIGHT 1996 2006 #

#"(C) Copyright 1996-2006 Hewlett-Packard Development Company, L.P."#

#IGNITE_UX_COPYRIGHT #

65