Using the Auto-Adjustment Function

You can optimize the screen performance for the VGA (analog) input by using the OK/auto button on the monitor and the auto-adjustment pattern software utility on the CD provided.

Do not use this procedure if the monitor is using a DVI or DisplayPort input. If the monitor is using a VGA (analog) input, this procedure can correct the following image quality conditions:

Fuzzy or unclear focus

Ghosting, streaking or shadowing effects

Faint vertical bars

Thin, horizontal scrolling lines

An off-center picture

To use the auto-adjustment feature:

1.Allow the monitor to warm up for 20 minutes before adjusting.

2.Press the OK/auto button on the monitor front panel.

You can also press the Menu button, then select Image Control > Auto-Adjustmentfrom the OSD Main Menu. Refer to Adjusting the Monitor Settings on page 19 in this chapter.

If the result is not satisfactory, continue with the procedure.

3.Insert the CD in the disc drive. The CD menu is displayed.

4.Select Open Auto-Adjustment Software. The setup test pattern is displayed.

5.Press the OK/auto button on the monitor front panel to produce a stable, centered image.

6.Press the ESC key or any other key on the keyboard to exit the test pattern.

ENWW

Using the Auto-Adjustment Function 17

Page 25
Image 25
HP LA2405wg manual Using the Auto-Adjustment Function