Using the Auto-Adjustment Function

You can optimize the screen performance for VGA (analog) input by using the - (Minus) button on the monitor and the auto-adjustment pattern software utility on the CD provided.

Do not use this procedure if the monitor is using a DVI-D, HDMI, or DisplayPort input. If the monitor is using a VGA (analog) input, this procedure can correct the following image quality conditions:

●Fuzzy or unclear focus

●Ghosting, streaking or shadowing effects

●Faint vertical bars

●Thin, horizontal scrolling lines

●An off-center picture

To use the auto-adjustment feature:

1.Allow the monitor to warm up for 20 minutes before adjusting.

2.Press the - (minus) button on the monitor front panel.

●You can also press the Menu button, then select Image Control > Auto Adjustment from the OSD Main Menu. Refer to Adjusting the Monitor Settings on page 23 in this chapter.

●If the result is not satisfactory, continue with the procedure.

3.Insert the CD in the disc drive. The CD menu is displayed.

4.Select Open Auto-Adjustment Software. The setup test pattern is displayed.

5.Press the - (minus) button on the monitor front panel to produce a stable, centered image.

6.Press the ESC key or any other key on the keyboard to exit the test pattern.

Using the Auto-Adjustment Function 21