MHP-TN USER INSTRUCTIONS ENGLISH 71576313 - 02/07

8.2 Sectional drawings part list

ITEM

DESIGNATION

 

 

1110

Pump casing

 

 

1221

Casing cover with stuffing box

 

 

1500

Wear ring

 

 

2110

Pump shaft

 

 

2250

Radial flow impeller

 

 

2450

Shaft sleeve

 

 

2540

Thrower

 

 

2905

Plain washer

 

 

2912

Self-braked nut

 

 

3011

Radial ball bearing

 

 

3134

Support foot

 

 

3200

Bearing housing

 

 

3260

Bearing cover

 

 

3300

Bearing bush

 

 

4120

Gland

 

 

4130

Gland packing

 

 

4132

Stuffing box neck bush

 

 

4590-01

Gasket

 

 

4590-02

Gasket

 

 

4590-03

Special ring

 

 

6511

Priming plug

 

 

6515

Drain plug

 

 

6544

Bore circlip

 

 

6569

Screwed plug

 

 

6572

Stud

 

 

6577-01

Hexagon bolt

 

 

6577-02

Hexagon bolt

 

 

6577-03

Hexagon bolt

 

 

6581

Hexagon nut

 

 

6700-01

Key

 

 

6700-02

Key

 

 

9331

Cover plate

 

 

8.3 General arrangement drawing

The typical general arrangement drawing and any specific drawings required by the contract will be sent to the Purchaser separately unless the contract specifically calls for these to be included into the User Instructions. If required, copies of other drawings sent separately to the Purchaser should be obtained from the Purchaser and retained with these User Instructions.

9 CERTIFICATION

Certificates determined from the Contract requirements are provided with these instructions where applicable. Examples are certificates for CE marking, ATEX marking etc. If required, copies of other certificates sent separately to the Purchaser should be obtained from the Purchaser for retention with these User Instructions.

10 OTHER RELEVANT DOCUMENTATION AND MANUALS

10.1 Supplementary User Instructions

Supplementary instructions such as for a driver, instrumentation, controller, seals, sealant system etc are provided as separate documents in their original format. If further copies of these are required they should be obtained from the supplier for retention with these User Instructions.

10.2 Change notes

If any changes, agreed with Flowserve, are made to the product after its supply, a record of the details should be maintained with these User Instructions.

10.3 Additional sources of information

Reference 1:

NPSH for Rotor dynamic Pumps: a reference guide, Euro pump Guide No. 1, Euro pump & World Pumps, Elsevier Science, United Kingdom, 1999.

Reference 2:

Pumping Manual, 9th edition, T.C. Dickenson,

Elsevier Advanced Technology, United Kingdom, 1995.

Reference 3:

Pump Handbook, 2nd edition, Igor J. Karassik et al, McGraw-Hill Inc., New York, 1993.

Reference 4:

ANSI/HI 1.1-1.5, Centrifugal Pumps - Nomenclature, Definitions, Application and Operation.

Reference 5:

ANSI B31.3 - Process Piping.

Page 27 of 28

flowserve.com