HP nc6000 manual Removing the Hard Drive Bracket and Connector

Removal and Replacement Procedures

ÄCAUTION: The hard drive should be disassembled only if it is damaged and must be repaired. Unnecessary disassembly of the hard drive can result in damage to the hard drive and loss of information.

g.Remove the two T5M3.0×4.0 screws 1 and the two PM3.0×3.5 screws 2 that secure the hard drive to the hard drive frame.

h.Use a 4.0-mm socket to remove the two M2.0×10.0 alignment pins 3 that secure the hard drive to the hard drive frame.

i.Remove the hard drive from the hard drive frame 4.

j.Remove the hard drive connector from the hard drive 5.

Removing the Hard Drive Bracket and Connector

Reverse the above procedure to reassemble and install the hard drive.

5–10 Maintenance and Service Guide