The monitor automatically scans the signal inputs for an active input and uses that input for the display. If two or more inputs are active, the monitor will display the default input source. If the default source is not one of the active inputs, then the monitor will display the highest ranking priority input in the following order: DVI then VGA. You can change the default source in the OSD by pressing the front panel Menu button and selecting Source Control > Default Source.
Removing the Monitor Stand
You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other mounting fixture.
CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected.
1.Disconnect and remove the signal and power cables from the monitor.
2.Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3.Remove the four screws (1) attaching the stand to the monitor and lift the stand (2) off the monitor. Figure
Mounting the Monitor
The monitor panel can be attached to a wall, swing arm, or other mounting fixture.
Removing the Monitor Stand | 9 |
