7Make sure the drive is pushed all the way in through the front of the chassis until it locks into place.
8Make sure the drive latch pin is fully inserted into the hole labeled (1).
9Complete the procedures to replace the front panel, replace the side panel, and close the PC. See “Opening and Closing the PC” on page 1.
Removing the HP Pocket Media or Diskette or Hard Disk Drive
1Complete the procedures to prepare the PC to remove the side panel and to remove the front panel. See “Opening and Closing the PC” on page 1.
2Release the HP Pocket Media or diskette (floppy), or hard disk drive, by removing the two screws on the side of the drive, and then slide the drive part way out of the front of the chassis.
Upgrading and Servicing Guide 11