HP SR5613CF, SR5558D, SR5548F, SR5518F, SR5518CF, SR5608F manual Removing or Installing an Add-in Card

2Set the chassis upright.

3Complete the procedures to replace the side panel, and close the PC. See “Opening and Closing the PC” on page 1.

NOTE: If a blank screen is displayed after replacing or adding a memory module, the memory is installed incorrectly or it is the wrong type of memory. Remove and reinstall the memory module.

Removing or Installing an Add-in Card

An add-in card is a circuit board, such as a PCI or an AGP card, that fits into a PC add-in card slot. Your PC contains several add-in card slots that can be used to add components to your PC. The PC component configurations vary by model.

WARNING: Do not overload the system by installing add-in cards that draw excessive current. The system is designed to provide two amps (average) of +5 Vv power for each board/card in the computer. The total +5 Vv current draw in a fully loaded system (one with all add-in card slots filled) must not exceed the total number of slots multiplied by two amps.

A flat-head and a Phillips screwdriver are needed to remove, replace, or add an add-in card.

NOTE: A power supply upgrade may be required for certain graphics card upgrades. Check with the graphics card supplier for more information about power supply requirements.

24Upgrading and Servicing Guide