Lun | VVName | HostName | Port Type | |
0 | srm_vol1 | 21000024FF223A1B | 1:1:2 host | |
0 | srm_vol1 | 21000024FF223A1A | 0:1:2 host |
2total
8.Discover the LUNs on the ESX(i) hosts.
9.After exporting the VLUNs to the ESX(i) host, rescan the HBA to verify if the VLUN is now visible to the ESX(i) host.
10.Create a VMFS Datastore.
11.Deploy VMs per your requirements on the protected site.
Configuring Remote Copy with IP between the protected and recovery sites
HP 3PAR Remote Copy Software provides the capability to copy virtual volumes from the protected site HP 3PAR storage system to the recovery site HP 3PAR Storage system.
Ensure that the HP 3PAR storage system hardware is set up appropriately for creating a Remote Copy configuration between the protected site and recovery site.
NOTE: SRM works with a Remote Copy setup using IP or Fibre Channel connectivity. This document describes the steps required to configure Remote Copy with IP. For more information about implementing Remote Copy over Fibre Channel, see the HP 3PAR Remote Copy Software User's Guide.
Initial setup for Remote Copy from the Protected Site
1.From the protected site (s230 in the following examples) set up the Gigabit Ethernet link.
root@inodee2023:~# controlport rcip addr
root@inodee2023:~# controlport rcip addr
root@inodee2023:~# controlport rcip gw
root@inodee2023:~# controlport rcip gw
2.Verify connectivity (s230).
root@inodee2023:~# showport |
|
|
|
| |
N:S:P State | IPAddr | Netmask | Gateway MTU | Rate Duplex | |
AutoNeg |
|
|
|
|
|
0:9:1 ready 0002AC8014A5 10.100.33.88 255.255.255.0 10.100.33.1 1500 | 1Gbps | Full | |||
Yes |
|
|
|
|
|
1:9:1 ready 0002AC80149F 10.101.33.88 255.255.255.0 10.101.33.1 1500 | 1Gbps | Full | |||
Yes
2
14 HP 3PAR storage system setup
