![](/images/new-backgrounds/1330591/3305915x1.webp)
Contents |
|
1 Introduction | 4 |
2 VMware vCenter Site Recovery Manager overview | 5 |
3 Supported configurations | 7 |
4 HP 3PAR SRA installation and configuration prerequisites | 8 |
5 Installing HP 3PAR SRA | 9 |
Removing HP 3PAR SRA | 9 |
Installing HP 3PAR SRA 5.5.2 | 9 |
Verifying installation | 9 |
6 HP 3PAR storage system setup | 10 |
Installing, configuring, and verifying the configurations on HP 3PAR storage system | 12 |
Configuring Remote Copy with IP between the protected and recovery sites | 14 |
Initial setup for Remote Copy from the Protected Site | 14 |
Initial setup for Remote Copy from the Recovery Site | 15 |
Setting up Remote Copy targets and links | 15 |
Creating Synchronous Remote Copy groups | 16 |
Adding a Virtual Volume to existing Remote Copy groups | 16 |
Displaying the Remote Copy groups configuration | 17 |
7 Configuring VMware vCenter Site Recovery Manager and HP 3PAR SRA | 18 |
Configuring HP 3PAR SRA | 19 |
Validating HP 3PAR StoreServ Storage SSL certificates | 21 |
8 Recovery and failback | 23 |
9 HP 3PAR SRA for the VMware SRM 5.5 utility | 26 |
10 Partial licensing | 28 |
11 HP 3PAR SRA 5.5.2 SRM vs HP 3PAR Remote Copy state diagram | 29 |
12 Special notes | 33 |
Support for multiple array pair configuration | 36 |
Support for virtual volume sets and host sets | 37 |
Support for SLD | 38 |
Workarounds for SLD error codes | 38 |
Limitations of SLD configuration | 38 |
13 Support and other resources | 40 |
Contacting HP | 40 |
HP 3PAR documentation | 40 |
Typographic conventions | 42 |
HP 3PAR branding information | 42 |
14 Documentation feedback | 43 |
Contents 3