ZCOM C I/F Library Routines

ZCONFIG (3X)

data.setterm.zaddr

ZLU of the related terminal. The “node” field is not used. For action 1 and 2, if ZLU is non-zero, it must be an unassigned one and ZLU checksum is not necessary. If ZLU is zero, the system chooses an arbitrary (unused) one. For actions ZcDSC_CLEAR_TERM, ZcDSC_DELETE_TERM, and ZcDSC_MOVE_TERM, the ZLU must be defined and the ZLU checksum must be valid.

data.setterm.daddr

ZLU of the destination terminal. It specifies the destination PTT to which the newly created terminal is linked. It must be a defined terminal and the checksum must be valid. The “node” field is not used. It is used for action ZcDSC_CREATE_LTT_ON_PTT only.

data.setterm.iftno

Interface card number (0, 1,...). It specifies to which interface card the new terminal is linked. This field is needed for actions ZcDSC_CREATE_LTT_PTT and ZcDSC_MOVE_TERM only.

data.setterm.portno

Port number in the interface card (0 to 7). It specifies to which port the new terminal is linked. This field is needed for actions ZcDSC_CREATE_LTT_PTT and ZcDSC_MOVE_TERM only.

data.setterm.subchno

Subchannel number on the port (0 to 31). It specifies the subchannel number the terminal will communicate over. Currently, only the Z7300A card supports subchannels. All other ACC interface card types must set this parameter to zero. This field is needed for actions ZcDSC_CREATE_LTT_PTT and ZcDSC_MOVE_TERM only.

data.setterm.dtype

Terminal device type. It is set up in the newly created terminal. This field is needed for actions ZcDSC_CREATE_LTT_PTT and ZcDSC_CREATE_LTT_ON_PTT only.

data.setterm.ltype

Logical terminal type. It is set up in the newly created terminal. This field is needed for actions ZcDSC_CREATE_LTT_PTT and ZcDSC_CREATE_LTT_ON_PTT only.

data.setterm.ltt

Chapter 4

221