Power Cord Set Requirements

The monitor power supply is provided with automatic line switching (ALS). This feature allows the monitor to operate on input voltages in the range of 100–240V, 50 / 60 Hz, 1.5A.

The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the country/region where the equipment was purchased.

If you need to obtain a power cord for a different country/region, you should purchase a power cord that is approved for use in that country/region.

The power cord must be rated for the product and for the voltage and current marked on the product’s electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the cross-sectional area of the wire must be a minimum of 0.75 mm² or 18AWG, and the length of the cord must be between 4.94 ft (1.5 m) and 12 ft (3.6 m). If you have questions about the type of power cord to use, contact your HP-authorized service provider.

A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from the product.

VGA Pin Assignments

DVI Pin Assignments

 

 

 

 

 

Pin Number

15-Pin Side of the Signal

 

 

 

Cable

 

 

1

Video-Red

 

 

2

Video-Green

 

 

 

 

 

 

3

Video-Blue

 

 

 

 

 

 

4

Ground

 

 

5

Detect Cable

 

 

 

 

 

 

6

GND-R

 

 

 

 

 

 

7

GND-G

 

 

8

GND-B

 

 

 

 

 

 

9

+5V

 

 

 

 

 

 

10

Ground

 

 

11

Ground

 

 

 

 

 

 

12

DDC-Serial data

 

 

 

 

 

 

13

H-sync

 

 

14

V-sync

 

 

 

 

 

 

15

DDC-Serial clock

 

 

 

 

 

23