Screws,

M2.5x4mm (2)

Screws,

M2.5x4mm (2)

Figure 9. Removing the Hard Disk Tray

Reassembly Notes

•Insert the connector end of the drive through the opening in the carrier, then lower the drive into place.

•Carefully slide the new drive into the hard drive compartment. Press firmly to make sure its connector seats properly.

Important

If you are installing a new hard disk drive, install the factory software and operating system on the drive before loading any additional software—see “Recovering the Factory Software Installation” on page 33.

36

Removing and Replacing Parts

ze1000 Series Troubleshooting and Self-Repair Guide