Setup functions (continued)

Command

Parameters

Description

 

 

 

FWVERS

?

Queries the projector firmware model number and firmware

 

 

version. Similar to VERS, but used to verify that a firmware

 

 

update image is appropriate for the projector. The

 

 

notification takes this form:

 

 

*VERS="proj_model:M.mmm"

 

 

 

IPADDR

Hex IP address, ?

Used by network module to tell projector the IP address to

 

 

display in the help menu.

 

 

SNET

Hex subnet mask, ? Used by network module to tell projector the subnet mask to

 

 

display in the help menu.

 

 

MAC

Hex MAC address, ? Used by network module to tell projector the MAC address

 

 

to display in the help menu.

 

 

 

SNUM

?

Queries the projector's serial number.

 

 

 

RSET

None

Restores all settings to defaults.

 

 

 

Power and status functions

Command

Parameters

Description

 

 

 

SHDN

None

Puts the projector into cool-down state, and later into standby

 

 

state. The projector sends a notification when it enters cool-

 

 

down state (STAT=3), and another when it enters standby state

 

 

(STAT=0). This keyword requires the projector to be in its on

 

 

state (STAT=1).

 

 

Do not send any requests other than STAT in the time between

 

 

the cool-down and standby state notifications. Otherwise,

 

 

unexpected results can occur.

 

 

 

W or WAKE

None

Puts the projector into warm-up state, and later into on state.

 

 

The projector sends a notification when it enters warm-up state

 

 

(STAT=2), and another when it enters the on state (STAT=1).

 

 

This keyword requires the projector to be in standby state

 

 

(STAT=0).

 

 

Do not send any requests other than STAT in the time between

 

 

the warm-up and on state notifications. Otherwise, unexpected

 

 

results can occur.

 

 

 

Connecting to a room controller 53