HP XW9400 manual System Technical Specifications

Models: XW9400

1 47
Download 47 pages 21.24 Kb
Page 10
Image 10

QuickSpecs

HP xw9400 Workstation

System Technical Specifications

System Board

 

Expansion Slots

2 PCI Express (PCIe) x16 75W+EXT75W (Graphics) slots

 

2 PCIe x16 (8,4,1) slots

 

Full-height PCI-X slots at 100 MHz, or 1 slot at 133 MHz, exclusive1 full-length PCI

Bays

Five 3.5 inch bays

 

Three 5.25 inch bays

Front I/O

4 ports: 2 USB 2.0, 1 headphone, 1 microphone, 1 IEEE 1394

Rear I/O

16 ports: 6 USB 2.0, 1 standard serial 9-pin port, 1 IEEE 1394, 1 PS/2 keyboard, 1 PS/2 mouse, 2 RJ-45

 

to integrated Gigabit LAN, 1 Audio In, 1 Audio Line Out, 1 Mic In, S/PDIF OUT coax

USB Keyboard

Optional

USB Mouse

Optional

PS/2 Keyboard

1

PS/2 Mouse

1

Memory

 

Maximum Memory

Supports up to 64 GB of DDR2 SDRAM, in a configuration of 32 GB per processor (over 32 GB requires

 

dual CPUs and Quad Ranked DIMMS when supported).

 

NVIDIA Nforce Professional 3000 Series

 

DDR2 SDRAM ECC REGISTERED MEMORY

 

This chart does not represent all possible memory configurations. Each AMD Opteron processor has an

 

integrated memory controller that supports ECC Registered 667 MHz (PC2 5300P) DDR2 or ECC

 

Registered 533 MHz (PC2 4200) DDR2 memory. Main memory is directly connected to the processor

 

through the Direct Connect Architecture. There are 8 DIMM slots in total, with 4 DIMM slots per processor,

 

each processor offering a memory bandwidth transfer rate up to 10.2 GB/s. Over 32 GB requires dual

 

CPUs, and will require 8 GB DIMMS (when available)

 

Memory must be added in pairs. Match DIMM pairs by size and type. Use only HP tested and validated

 

memory

 

In a single processor configuration, install the first DIMM pair in socket set 1 (blue sockets), and the 2nd

 

DIMM pair in socket set 3 (black socket).

 

In a dual processor configuration, install the first DIMM pair in socket set 1 (blue sockets), the 2nd DIMM

 

pair in socket set 2 (blue sockets) and, if required, the 3rd pair in socket set 3 (black sockets) and the 4th

 

pair in socket set 4 (black sockets).

 

The memory sockets are laid out on the mainboard as below:

Memory configurations for the HP xw9400 Workstation:

DA - 12594 Worldwide — Version 27 — May 8, 2009

Page 10

Page 10
Image 10
HP XW9400 manual System Technical Specifications