Hubbell Type D6 14A-11, Type D7 Switches - Unitized, Unitized and Pre-Assembled, 15 to 38 kV

®

POWER SYSTEMS, INC.

Unitized and Pre-Assembled

Type D7 Switches  —  Unitized

15 to 38 kV 600 Amperes

®

14A-11

Chance 15.5, 27 and 38 kV Duogap expulsion interrupters .

Design Features

The jaw socket and hinge terminal castings of the D7 are bronze with tin-plated NEMA terminal pads. The blade is a round tubular copper with flattened ends to allow for a silver/copper contact. A four-point silver plated contact is supplied on the jaw end to make the switch easier to open and close. An all-copper current path is provided.

Interrupters

Chance Duogap® expulsion interrupter converts any D7 to a loadbreak switch. Built-in sockets on each switch accept the interrupter. The Duogap may be ordered with the switch or may be hotstick-installed for load management conversion. For more on the Duogap, see Bulletin No. 14-9405.

Terminal Pads, Arcing Horns

Two-hole NEMA terminal pads are standard. The D7 terminal pads are bronze with tin-plating to provide low-resistance efficient current transfer.

A stainless steel arcing horn is provided to pick up load current, thus preventing burning or arc pitting on the main contacts.

Insulators

The Vee configuration of the insulators simulates a low profile with less bulk and a pleasing visual appearance. The gray-tone insulator for the unitized D7 switch is NEMA 3-inch BC.

15 thru 34.5 kV Switch Base and Bearings

The base castings consist of high strength, high corrosion resistant aluminum alloy. This lightweight aluminum is comparable to bronze in almost all metal technical categories, such as: ultimate tensile, tensile yield, elongation, hardness, modulus of elasticity, thermal conductivity, and electrical conductivity. Bearings are high-strength, high-density Delrin, for smooth pivotal action.

Conductors are dead-ended to each individual switch base. Pull-off holes are designed for a 6,000-lb. working load rating. The switch frame is limited to an unequal loading of 700 lb.

Common Support

The 4 x 4-inch common support member is furnished in either galva- nized-steel or fiberglass tubing. The “interphase” shaft which connects the three rotating insulators is constructed of the same material as the crossarm.

Controls

Controls are either all metal or metal with a vertical fiberglass section. Three options combine the metal or insulated interphase shaft with the metal or fiberglass common support.

The arcing horn will pick up load current upon closing to prevent burning or arc pitting on the main contact surfaces.

HUBBELL / CHANCE COMPANY – CENTRALIA, MISSOURI SEPTEMBER 2007