RECOMMENDED TOOLS
zLong
zMedium Size Flat Head Screw Driver
zBrass Ball Peen Hammer
zFlat Bastard File
z240 Grit Sand Paper
z
z
z12” Crescent Wrench
zShop Towels
z
z25 ft. Measuring Tape
zPencil or Marker
zOpen/Box End Wrench Set (1/2” -
zSocket Set for 1/2” Drive (1/2” -
zTorque Wrench(s) Rated for
INSTALLATION PROCEDURES
ASSEMBLY WITH BUSHING
Clean all mating surfaces between hub, bushing and shaft. If there is no shoulder on shaft to prevent bushing from sliding down shaft, slide spacer/sleeve (not provided) on shaft before bushing. Slide bushing and key onto shaft until flush with end of shaft. Lock
ASSEMBLY WITH STRAIGHT SHAFT (NO BUSHING)
Clean all mating surfaces between the hub and the shaft. If there is no shoulder on shaft to prevent hub from sliding down shaft, slide spacer/sleeve (not provided) on shaft before hub or use a thrust retainer (optional equipment) on top of hub. Install key in shaft. Line up key and keyway and set hub on shaft. Tighten two (2) set
screws in hub.
ASSEMBLY WITH TAPERED SHAFT (NO BUSHING REQUIRED)
Clean all mating surfaces between hub and shaft. Coat all mating surfaces with an
Align keyways and install hub. Install retainer plate and cap screw(s) with lock washer(s). Shaft size determines what size cap screw is necessary. Using a torque wrench with a socket, evenly tighten cap
screw to recommended standard per table below.
|
| Torque Value | ||
Cap Screw | Socket |
| ||
Size | Size | Lubricated |
| Dry |
5/8” NC | 15/16” | 100 |
| 110 |
3/4” NC | 125 |
| 130 | |
1” NC | 150 |
| 160 |
NOTE: Retaining arrangement varies with gear shaft design.
ASSEMBLE BLADE CLAMP ON BLADE NECK
Remove blade clamp studs, lock washers, and blade clamp halves from hub. Assemble blade clamp halves over groove in blade neck, with thick leading edge to left and thin trailing edge to right as you stand at end of blade. Use a band clamp to hold the two blade clamp halves in position on the blade for installation in the hub body (See Figure 1).
Figure 1
Installation Manual 8000 | Page 2 of 8 | January 2004 |