1. | Identify pole sections. | MIDDLE |
|
2
1
5"
(13 cm)
TOP
ID Sticker
5"
(13 cm)
3
BOTTOM
ID Sticker
While maintaining alignment, bounce middle pole section (2) into top section (1)
2.using a wood scrap as shown until the top pole no longer moves toward the pole identification sticker on the middle pole.
IMPORTANT!: |
| NOTE: | |
| POLE SECTIONS | ||
Align dimple of top pole section (1) |
| SHOULD HAVE A | |
| |||
into trough of middle pole section (2) | MINIMUM OVERLAP. | ||
| |||
as shown. |
|
| CAUTION! |
|
|
| |
pole em | ID |
| THE IDENTIFICATION STICKER IS |
| LOCATED 5" FROM THE END OF | ||
| STICKER |
| |
|
| THE POLE. WHEN PROPERLY | |
|
|
| |
TROUGH |
| 2 | POUNDED TOGETHER, THE POLE |
| SECTIONS SHOULD HAVE A | ||
5" |
|
| MINIMUM OVERLAP, LEAVING 1- |
|
| 1/2" BETWEEN THE OVERLAPPING | |
| pole middle | POLE AND THE IDENTIFICATION | |
| STICKER. | ||
|
| ||
|
|
| |
| DIMPLE | 1 |
|
|
|
| |
| HOLE |
| WOOD SCRAP |
|
| (NOT SUPPLIED) | |
|
|
| |
P/N 21157301 09/04 |
| 8 |
|
