Huffy ATVUSB05 manual Upright assembly

4. IMPORTANT! Center alignment slot of middle pole section (5) in a lower hole of top pole section (4) as shown. While maintaining alignment, bounce middle pole

(5)into top pole section (4) as shown until top pole section no longer moves toward taped reference mark on middle pole.

Upright assembly.

NOTE:

POLE SECTIONS

SHOULD HAVE A

3-1/2" (9 CM)

MINIMUM OVERLAP.

WOOD SCRAP

(NOT SUPPLIED)

5

4

5.IMPORTANT! Center alignment slot of lower pole section (6) in a lower hole of middle pole section (5) as in step 3. While maintaining alignment, bounce top & middle pole assembly (4 & 5) onto lower pole section (6) as shown until top & middle pole assembly no longer moves toward taped reference mark on bottom pole.

NOTE:

POLE SECTIONS

SHOULD HAVE A

3-1/2" (9 CM)

MINIMUM OVERLAP.

4

5

6

WOOD SCRAP

(NOT SUPPLIED)

P/N 214954E 01/04 10