4.Bounce top and middle pole assembly (4 & 5) onto bottom pole section (6) using a wood scrap as shown. Bounce until the top and middle pole assembly no longer moves toward the pole identification mark on the bottom pole.
IMPORTANT!:
Align dimple of middle pole section (5) into trough of bottom pole section (6) as shown.
| TROUGH | |
| Bottom pole | |
|
| |
5" |
| ID |
|
| STICKER |
Bottom pole
DIMPLE
HOLE
5
CAUTION!
THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A
MINIMUM OVERLAP, LEAVING 1- 1/2" BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.
4
RODS SHOWN ARE
FOR VISUAL
REPRESENTATION
OF ALIGNMENT
AND ARE NOT
SUPPLIED WITH
THE HARDWARE
6
WOOD SCRAP
(NOT SUPPLIED)
ID# M671111 | 07/05 | 14 |
