3. Bounce top and middle pole assembly (4 and 5) onto bottom pole section (6) using a wood scrap as shown. Bounce until the top and middle pole assembly no longer moves toward the pole identification mark on the bottom pole.
IMPORTANT!
Align dimple of middle pole section (5) into trough of bottom pole section (6) as shown.
Bottom pole
5" | ID |
STICKER
CAUTION!
THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A
BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.
Bottom pole
DIMPLE
HOLE
4
5
RODS SHOWN ARE
FOR VISUAL
REPRESENTATION
OF ALIGNMENT
AND ARE NOT
SUPPLIED WITH THE HARDWARE
6
WOOD SCRAP
(NOT SUPPLIED)
11 | 01/06 | ID# M732201 |