CHANNEL SELECT: This channel selector switch activates either the CLEAN or OVERDRIVE channel. The OVERDRIVE channel is active when the button is pressed.
RED OVERDRIVE LED: The red LED illuminates when the OVERDRIVE channel is active.
MODE: Overdrive Mode button; it allows you to switch back and forth between two distinct overdrive characteristics.
OVERDRIVE GAIN: Controls the amount of distortion in the OVERDRIVE channel.
OVERDRIVE MASTER: Determines the OVERDRIVE channel volume level in relation to the CLEAN channel volume level.
EQ SECTION: Common BASS, MID and TREBLE controls for the both channels. MID and TREBLE controls influence each other, as is standard in tube amps: if you boost the treble, the mids are cut and vice versa. This
DELAY: Varies the delay time.
FEEDBACK: This knob controls the amount of feedback for the delay effect.
CHORUS RATE: Controls the rate or speed of the chorus effect.
REVERB: Controls how much integrated reverb is added to the signal. Reverb is automatically adjusted for each channel when you switch channels.
MASTER: Controls the amp‘s master volume level. The LINE OUT signal is unaffected by the MASTER control.
REAR PANEL:
LINE OUT: Use this jack to feed the signal to the input of an
FX processor. You can also route the signal to a second power amp or through a RED BOX to a mixing console.
LINE IN: If you are sending the LINE OUT signal to an FX processor, connect the output from that processor to this jack.
FOOTSWITCH: This jack is for a standard footswitch (e.g. Hughes
&Kettner
is set to CLEAN.
PHONES: Headphone jack. The speaker is automatically switched off when a plug is inserted into this jack.
MAINS: Connect the included
