Humax ND-1200C Safety

Safety

11

1. STANDBYLED

Red light is emitted when the product is in STANDBYmode.

While watching the analog Fee-To-Air Channels, the Set-Top Box should be in the

STANDBYmode.

2. SMART CARD SLOT

Slot for a smart card.

The Smart Card is to be placed in the slot with the red arrow “Insert card this way up”

facing upwards (i.e. Chip-side downwards).

NOTE: THE CARD IS TO BE INSERTED GENTLYTILL IT STOPS AND REMAINS

APPROX. 1 CM OUTSIDE.

1.2 Front Panel

12

1. CABLE IN

Connect the incoming Cable-TV signal to the CABLE IN jack on the Set-Top Box.

2. CABLE OUT

Connect the outgoing cable from CABLE OUT to the TV set.

3. AUDIO R/L

Connect the AUDIO R to the TV AUDIOIN and AUDIO L to the TV AUDIO INusing

RCA-RCA cord.

4. VIDEO

Connect the VIDEO to your VIDEO IN of TV / VCR using RCA-RCAcord.

1.3 Rear Panel

1 2 3 4

Contents

Main Notice SPECIAL NOTICE Notice Warnings, Cautions, and Notes Safety and Warning Safety Instructions and Precautions Warning Page Page Contents 1. Before using the Set-Top Box 2. Setup 3. Watching a Cable Channel 4. Using the EPG (Electronic Programme Guide) 9 5.5 Other Function of EPG Precautions Specifications Page Safety 1.2 Front Panel 1.3 Rear Panel 1. Before using the Set-Top Box 1.4 Remote Control Page Page 2.2 Powering On 2.3 Configuration of the Set-Top Box 3. Watching a Cable Channel 3.1 Turning the TV on for the first time after configuring Set-Top Box 3.2 To Select a Channel 3.3 To Adjust the Volume 3.4 To Mute Sound Page Page 4. Using the EPG (Electronic Programme Guide) 3. Menu Map 4. Using the EPG (Electronic Programme Guide) OVERVIEW OF FREQUENTLYUSED FUNCTIONS 5.1 Using the Programme Guide Page Page 5.2 Using Favourite Channel Page 5.3 Searching by Programme Types Page 5.4 Using Parental Lock Function Page 5.5 Other function of EPG Page Page Page Page Page Page Page Page Page Page Page Page Precautions HARDWARE SPECIFICATIONS Specifications SOFTWARE SPECIFICATIONS NB: The above specifications are subject to change without prior notice.