Humax ND-1200C - page 41

40

5. Functions Guide

Caution: This function is for installation personnel only.

Please do not use this function, if you are not familiar with the procedures for

configuration of Set-Top Box environment.

The selected screen consists of the following 5 menus.

Each menu provides the following function.

•Select Your Signal

To check the signal reception status, complete the following procedures.

1. Press the OK ( )button in the System Settings menu.

2. The Channel select screen appears.

Select the appropriate Channel, and press the OK ( )button.

Displays current signal status of the selected Channel by displaying signal

strength, signal quality and BER (Bit Error Rate). If the Set-Top Box is not properly

installed or there is a problem, the values displayed are very low.

6. System Settings

Contents

Main Notice SPECIAL NOTICE Notice Warnings, Cautions, and Notes Safety and Warning Safety Instructions and Precautions Warning Page Page Contents 1. Before using the Set-Top Box 2. Setup 3. Watching a Cable Channel 4. Using the EPG (Electronic Programme Guide) 9 5.5 Other Function of EPG Precautions Specifications Page Safety 1.2 Front Panel 1.3 Rear Panel 1. Before using the Set-Top Box 1.4 Remote Control Page Page 2.2 Powering On 2.3 Configuration of the Set-Top Box 3. Watching a Cable Channel 3.1 Turning the TV on for the first time after configuring Set-Top Box 3.2 To Select a Channel 3.3 To Adjust the Volume 3.4 To Mute Sound Page Page 4. Using the EPG (Electronic Programme Guide) 3. Menu Map 4. Using the EPG (Electronic Programme Guide) OVERVIEW OF FREQUENTLYUSED FUNCTIONS 5.1 Using the Programme Guide Page Page 5.2 Using Favourite Channel Page 5.3 Searching by Programme Types Page 5.4 Using Parental Lock Function Page 5.5 Other function of EPG Page Page Page Page Page Page Page Page Page Page Page Page Precautions HARDWARE SPECIFICATIONS Specifications SOFTWARE SPECIFICATIONS NB: The above specifications are subject to change without prior notice.